Orphan Attachments 07/31/2018I have been doing some housekeeping lately and I've noticed that I had a lot of orphaned attachments. Attachments get orphaned when the PM or post is deleted without removing the attachment first. Deleting a PM or post does not delete the attachment and the file or image remain on the server. I'd like to ask all members to go through their attachments and delete any attachments you don't need anymore or those that have been orphaned. Where can I get a list of my attachments? Click on your display name in the upper right corner of the forums and pick "My Attachments" from the drop-down list. How can I tell an attachment is orphaned? If the PM has been deleted, you'll see a message like this in your attachment list: Unfortunately there is no message if the post has been deleted, so please check your old posts. We do purge old birthday threads every once in a while. Also some hosted projects have been shut down, so you may have orphaned attachments on one of those locations. Thanks!
Search the Community
Showing results for tags 'Audacity'.
Found 1 result
Recording with Audacity I've written this guide to supplement Audacity's Recording guide, so I recommend reading Audacity's guide first to get started. Recording Levels The most common issue I've run into while processing actors' recordings is that the level is too low. If your recording level is too low, then I can't get a good enough sample of your voice and the recording will have poor quality when I amplify it. You must set the recording level, or gain, so that the maximum peak is between -3 and -6 dB on the recording meter. The peaks will be around 0.5 in the waveform. Here is a screenshot showing a recording that is too low and two waveforms with the correct levels: The recording levels are too low in the first waveform. The second and third waveforms are examples of the correct recording levels. In the third waveform, the positive and negative levels are different. It's the maximum amplitude that dictates the correct recording level. Opposite End of the Spectrum - Clipping When your recording levels are too high, the tops of the waveforms will be lopped off at 0 dB. This is called clipping. You can attempt to repair clipping in Audacity, but it's better to redo the recording since clip fixing involves interpolating the lost signal - basically a best guess. Here's a track with clipping: When you're recording, you need to monitor the waveform and adjust the recording levels appropriately. Setting the Recording Level In Windows, set the recording volume to 50% in the Sound control panel or in the control panel for your sound card. Open Audacity and configure it as instructed in the Recording manual page, linked above. In the recording levels meter at the top of your screen, click the link to turn on monitoring. Now create a test track. While you are talking into your microphone, the meter should peak between -3 and -6 dB and the waveform should be around 0.5 if you have it set to display the linear waveform, which is the default. If the levels are too low, then move the recording level slider towards the plus sign to increase the gain. If the levels are too high, then move the slider down towards the minus sign. You'll have to monitor the recording levels continuously as you record. If you have to yell, laugh or scream, then you'll probably have to lower the gain. You should turn on Show Clipping (View - Show Clipping) so that you can see when your recording is getting clipped. A clipped recording will have red vertical lines showing the clipped sections with Show Clipping turned on. Clipping means the gain is too high and you'll have to lower it and re-record the line. Recording Channels One last little detail, for the games that we're currently working with, you need to do your recordings in Mono. Select Mono from the Recording Channels drop-down.